Air Helper Springs
Air Helper Springs, Firestone, fits Snow Plow Trucks, Cargo Vans
Firestone introduces their Ride-Rite air helper springs and Coil-Rite air helper springs for work and pleasure. Air helper springs were made for snow plows. Snowplows cause original equipment front leaf and coil springs to fatigue thus losing suspension performance and alignment. Firestone has capitalized on this fatigue problem and introduced new Ride-Rite air helper springs and Coil-Rite front and rear axle air helper springs for popular 2X4 and 4X4 pickups to solve these problems. Air Helper Springs
Coil-Rite
Provides lift assistance to a coil sprung suspension, with a carrying capacity of up to *1000lbs. per set. Front Suspension
Ride-Rite
Provide assistance to a leaf spring suspension, capable of *5000 lbs. lift capacity at 100 p.s.i., enhancing the ride of your vehicle.
Air Command
2158 Level Command II Standard Duty Compressor Single Gauge Inflates Air Springs Equally.
Dual Air Command
2168 Dual Air Command Heavy Duty Compressor Dual Gauge Inflates Air Springs Individually.
Pro-Wing Plow Attachment
Pro-Wing provides an additional 20" of blade width with a minimal increase in plow weight. Trailoff is reduced and problem areas such as parked cars or moving snow across a lot becomes manageable. Plowing time can be reduced from 25-50%. Pro-Wings fit 98% of pickup mounted snow plows. Pro-Wings are not recommended for Meyer®® 2 meter, Western®® 8 1/2', or any brand 9' or 10' plows, except for Meyer®® 9'. Installation is a short two hours without special tools, and then just 3 quick pins per side to remove or replace each wing in seconds. The tripping action of your plow is unaffected by Pro-Wings. The rubber edge on the wings is long lasting and helps prevent damage to the wings. U.S. PATENT #4-962-600 PW-22 - Pro Wing Plow Attachment Price (see online catalogue) RE-20500 - Rubber Edge Only Price ea.
Non-Stick Snow Plow Liner
153-9628 - Yellow 153-9630 - Red . Non Stick Surface . No More Repainting Moldboard . (9) Stainless Steel Carriage bolts with nuts included . Available in Red or Yellow . One size only: 96" x 28" Trim with aviation snips or sharp knife to fit your plow.
Snow Plow Dolly
- 3 heavy-duty powder coated steel bases rated at 1000 lbs each.
- No special tools needed. Just hook the plow, raise it up and go.
- Allows you to easily store your snow plow in areas you normally wouldn't.
- Adjust and keep the plow at the proper height with the Plow Level-RTM attachment.
- Eliminates aches, pains, and frustrations when trying to hook up your plow in freezing weather.
Poly Snow Deflector
This deflector, rigid yet flexible comes in a standard 8' length and can be easily cut down to any desired length. Constructed of polyethylene, will not crack in cold weather.
- Roll snow better than standard deflectors
- Snow won't stick up in it
- Won't shatter or break even in below freezing weather
