Mill Supply Logo 
800-888-5072

Quality Parts, Discount Prices, Same Day Shipping

 
Parts that Fit

Fisher Snow Plow Cutting Edges

Buy Parts Now! Snow Plow Specials

Mill Supply, Inc. carries a variety of high-carbon steel edges to fit the Fisher Plows. These replacement high-carbon steel edges have high wear resistance due to superior surface hardness. Most of our edges can be shipped out to our customers the same day by U.P.S. or, if you are ordering more than one it would be to your advantage to ship by freight. Edges that fit Fisher have pre-punched holes and will replace your existing cutting edge with minimal effort. Mill Supply has edges to replace on the Fisher plow from the 7 1/2 feet to 10 feet in length. All of the high-carbon steel edges we carry for Fisher are 3/8” thick and have a top punch hole. Buy Cutting Edges Now

Order your cutting edge Bolts and Nuts Separately. Mill Supply has packaged carriage bolts in quantities of 9 and 12. Be sure to add this carriage bolt set, with locking nuts included, when you order your plow edge.

We realize when your plow breaks, you need parts fast, therefore we carry a large inventory and  provide same day shipping. You get good prices, large selection and superior service all in one stop. You can order parts online now, request a free catalog or call our store toll free at 800-888-5072. Our staff is trained and knowledgeable about your plow. Also, if you have questions about what you need to repair on your unit see our  troubleshooting page. We also carry parts for all other major brands including Diamond, Western and Meyer.

Edges - Rubber

Fisher Rubber Cutting Edges

Rubber Edges are ideal for slushy wet parking lots. Made of extremely durable rubber, our rubber edges act as a squeegee to do a superior cleanup job. Mill Supply stocks a variety of sizes for the Meyer and Western plow but can make custom order edges for any plow in a relatively short time of under two weeks. Rubber edges are reversible for extra long use and use slotted holes. The slotted holes allow you to adjust your rubber cutting edge as it wears. Your original steel cutting edge is inverted and mounted to act as a large washer to keep your new rubber cutting edge in place. Rubber cutting edges less than 72 inches in length are 6 inches tall by 1 inch thick. Larger cutting edges measure from 8 to 12 inches tall and are 1 ½ inches thick. New mounting hardware, containing longer bolts with nuts is included with each rubber cutting edge.

Mill Supply carries pre-manufactured sizes for Meyer and Western plows. Other sizes are custom manufactured for each customer. For Fisher Rubber Cutting Edges, Call: 1(800)888-5072. (Please have on hand your measurements: width of plow blade, number of bolt holes, width between hole centers.)

©2014 Mill Supply, Inc. (All Material on this page including but not limited to information about parts that fit Fisher is copyright by Mill Supply, Inc. 2014)