Mill Supply, Inc. carries a variety of high-carbon steel edges.. These replacement high-carbon steel cutting edges have high wear resistance due to superior surface hardness. Most of our edges can be shipped out to our customers the same day by U.P.S. or, if you are ordering more than one it would be advantageous to ship by freight. Cutting edges that fit Meyer® have pre-punched holes and will replace your existing cutting edge with minimal effort. Mill Supply has cutting edges to replace the Meyer®; Two Meter 78”, ST-72, ST-78, ST-84, ST-90, C-8, C-8.5, M-9, and M-10. Most cutting edges are 3/8” thick but the ST-90, our 90” cutting edge with 8 holes, is also available in ½” thick. Meyer Cutting Edges STORE.

Order your cutting edge Bolts and Nuts Separately. Mill Supply has packaged bolts in quantities of 6, 8, 9 and 12. Be sure to add this carriage bolt set, with locking nuts included, when you order your cutting edge. Meyer Cutting Edges STORE.

Meyer® is one of the leading snowplow and snowplow parts manufacturers. Mill Supply carries parts that fit their snowplow, including cutting edges. We realize when your snowplow breaks, you need parts fast, therefore we carry a large inventory and  provide same day shipping. You get good prices, large selection and superior service all in one stop. You can order parts online now, request a free catalog or call our store toll free at 800-888-5072. Our staff is trained and knowledgeable about your plow. Also, if you have questions about what you need to repair on your Meyer® snowplow, see our  troubleshooting page. We also carry parts for all other major brands including Diamond®, Western® and  Fisher® Buy Parts that fit Meyer® Now

Rubber

Rubber Edges that fit Meyer® snowplows are ideal for slushy wet parking lots. Made of extremely durable rubber our rubber cutting edges act as a squeegee to do a superior cleanup job. Mill Supply stocks a variety of sizes for the Meyer® and Western® plow but can make custom order edges for any plow in a relatively short time of under two weeks. Rubber cutting edges are reversible for extra long use and use slotted holes. The slotted holes allow you to adjust your rubber cutting edge as it wears. Your original steel cutting edge is inverted and mounted to act as a large washer to keep your new rubber cutting edge in place. Rubber cutting edges fewer than 72 inches in length are 6 inches tall by 1 inch thick. Larger cutting edges measure from 8 to 12 inches tall and are 1 ½ inches thick. New mounting hardware, containing longer bolts with nuts is included with each rubber cutting edge

Mill Supply carries pre-manufactured sizes for Meyer® and Western® plows. Other sizes are custom manufactured for each customer. For Custom Cutting Edges, Call: 1 (800) 888-5072.

Meyer® Lift Covers